If you simply bought a home theatre system or a set of speakers, you will need some tips on properly setting it up in the event that you don’t desire to hire an installer. You might think you are technically savvy and that installing your home theater system will be a snap. I will give some recommendations that will allow you to avoid some commonly made mistakes.
After unpacking your home theater system, you will usually find one central component as well as 5 or 7 speakers 音響店推薦. The central component will probably provide the audio for your entire speakers that you will set up. This central component can also be known as surround sound receiver or amplifier. It’s the central hub of your home theater system.
Ensure that you add this receiver in a location that’s fairly centrally located to minimize the total amount of speaker wire that you might want to run. You don’t necessarily need to place the receiver right alongside your TV. Just make certain it’s in a dry and safe place. Also, make certain that it is possible to reach the receiver from your TV or DVD/Blue-ray player when you will have to connect these.
Connecting the receiver to power and to your TV or DVD is fairly straightforward. Most contemporary TVs have an optical output which connects right to your receiver using a fiberoptical cable. This cable may possibly not be added with your system but it can be acquired at any electronics store. However, setting up your speakers might be a bit more tricky.
If you have wireless rear speakers you will not need just as much speaker cable and the setup will be somewhat easier. First of all, measure simply how much speaker cable you’ll need. Be sure to add some extra cable to consider those bends and corners. Select the gauge of the speaker cable depending how much power you intend to drive your speakers with. The bigger the power the thicker the speaker cable. Your subwoofer will usually have an integrated amp and connect with your receiver via RCA cable.
When connecting the speaker cable, make certain that you connect the cable with the best polarity. Each speaker has a shade coded terminal, usually red and black. Choose a speaker cable that shows one strand in an alternative color compared to other. Then connect the cable to any or all speakers the exact same way. Then, when connecting the speaker cable to your receiver, make sure that you connect the cable to each speaker terminal at the receiver in the exact same manner. This can keep the sound likely to each speaker in the right phase and optimize your sound experience.
Wireless rear speakers will typically incur an audio delay during transmission. This delay is also known as latency. Often the latency ranges between 1 and 20 ms. For optimum effect, it is better if most of the speakers have been in sync. If you have a system that uses wireless rears and wired front speakers, i.e. you’ve a mixture of wireless and wired speakers, you must try to delay the audio likely to the wired speakers by the latency of the wireless speakers.
Talk with the maker if your surround receiver could be set to delay the audio of specific channels. If you’re using wireless rears, you intend to set the front-speaker and side-speaker channels to delay the audio. Home theatre systems that have been not made for wireless rear speakers may not have this capability. In this case you may want to choose a wireless speaker kit that’s really low latency, ideally less than 1 ms. This can keep your entire speakers in perfect sync.