If you merely bought a home theater system or some speakers, you might need some tips about properly configuring it if you don’t desire to hire an installer. You may be thinking you’re technically savvy and that installing your home theatre system will be a snap. I will give some recommendations that will allow you to avoid some commonly made mistakes.
After unpacking your home theatre system, you will often find one central component along with 5 or 7 speakers 音響店推薦. The central component will probably give you the audio for all your speakers which you are likely to set up. This central component can be referred to as surround sound receiver or amplifier. It’s the central hub of your home theater system.
Ensure that you place this receiver in a spot that is fairly centrally located to minimize the quantity of speaker wire that you’ll require to run. You don’t necessarily need to put the receiver right alongside your TV. Just make certain it is in a dried and safe place. Also, make certain that it is possible to reach the receiver from your own TV or DVD/Blue-ray player as you should connect these.
Connecting the receiver to power and to your TV or DVD is fairly straightforward. Modern TVs have a visual output which connects right to your receiver using a fiberoptical cable. This cable might not be included with the body but it can be obtained at any electronics store. However, creating your speakers can be a little more tricky.
When you have wireless rear speakers you will not need as much speaker cable and the setup is going to be somewhat easier. To begin with, measure how much speaker cable you’ll need. Make sure to then add extra cable to take into consideration those bends and corners. Select the gauge of the speaker cable depending how much power you wish to drive your speakers with. The higher the power the thicker the speaker cable. Your subwoofer will often have an integrated amp and connect with your receiver via RCA cable.
When connecting the speaker cable, make certain that you connect the cable with the right polarity. Each speaker has a shade coded terminal, usually red and black. Select a speaker cable that shows one strand in a different color compared to other. Then connect the cable to any or all speakers exactly the same way. Then, when connecting the speaker cable to your receiver, ensure that you connect the cable to each speaker terminal at the receiver in exactly the same manner. This can keep the sound going to each speaker in the correct phase and optimize your sound experience.
Wireless rear speakers will typically incur an audio delay during transmission. This delay is also referred to as latency. Usually the latency ranges between 1 and 20 ms. For optimum effect, it is better if most of the speakers have been in sync. When you have something that uses wireless rears and wired front speakers, i.e. you’ve a mixture of wireless and wired speakers, you must make an effort to delay the audio going to the wired speakers by the latency of the wireless speakers.
Check with the maker if your surround receiver may be set to delay the audio of specific channels. If you should be using wireless rears, you wish to set the front-speaker and side-speaker channels to delay the audio. Home theatre systems which were not created for wireless rear speakers may not have this capability. In this case you may want to locate a wireless speaker kit that has really low latency, ideally less than 1 ms. This can keep all your speakers in perfect sync.